Get paid To Promote at any Location Handphone: The phone saves the Affected Water

Senin, 14 Desember 2009

The phone saves the Affected Water

Have your phone suddenly fell into the water? Then suddenly the phone can not be used anymore, aka death total? How is the solution?

If you experience something like that should not panic, even when considering the price of phones that millions favorite, the mind can be stressful. In this article, we will discuss ways of handling a wet cell phone. If your phone is new with warranty, forget about warranty issues. Service center for phone vendors obviously will refuse warranty if the phone has proven to be exposed to fluids, although the warranty seal still intact. A consumer has rejected as to add a warranty claim for a damaged cell phone, on the grounds wet. And cell phone was never exposed to water. After further investigation it damaged cell phone because it is often exposed to sea winds, which can also cause corrosion on the phone.

Drain

The first step should be done if the phone is under water, try to quickly pull up and immediately the phone battery. Immediately dry the outside of the phone with a clean rag or tissue, so that water does not enter more and more into the phone. If you do not intend to open the inside of the phone, you can use a hair dryer to dry it. After the outside dried, the casing and the PCB in the phone must be opened to drain the water remains trapped inside. If not immediately dried, then the components in it will experience corrosion and phone can not be repaired anymore. Especially if exposed to sea water, the components will experience faster corrosion. To open the lock bolt is usually required phone casing eyed T6 screwdriver. In a candy bar phone models are usually easy to open, while the clamshell model is more difficult. Once the phone is open, clean water remains a liquid cleaners such as paint thinner, IPA, or alcohol. To dissolve the dirt and residue attached to the components in the PCB, can use a toothbrush or with the help of PCB cleaner (Ultrasonic Cleaner).

Power Supply

Once dry, plug it in again and try to turn on the phone using a battery or by using the Power Supply. By using the Power Supply, which shorted out the components exposed to water can be easily detected. If the phone back to a flame, then the problem is solved. If not, then watch the movement of currents in the Power Supply. If no reaction, the possibility of problems at the circuit power supply regulator IC on the phone or at the switch on / off the phone. If there is a reaction to the Power Supply current, the next step to do data repair software on the phone. The trick is to use the software and flashing the appropriate data cable. If the flashing process is successful, usually the phone will light up again. When the flashing process fails, there is the possibility of damage to the phone's processor and memory that needs to be checked further hardware or replacement of these components.

Tidak ada komentar:

Posting Komentar

 
Custom Search